Allen-Bradley 1770-M10 Manual de instalación Pagina 10
- Pagina / 136
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
• Chapter 2: About 8720MC-RPS Regenerative Power Supply
Identifies components of the 8720MC-RPS
Regenerative Power Supply, shows their locations,
and describes the main components.
• Chapter 3: Installation
Describes how to mount the 8720MC-RPS
Regenerative Power Supply properly.
• Chapter 4: Wiring
Describes how to properly wire and connect the
8720MC-RPS Regenerative Power Supply.
• Chapter 5: Start and Adjustment
Provides information on how to perform a final
check before power is applied, and instructions on
basic operation.
• Chapter 6: Operation Panel
Describes the composition and contents of the
operation panel.
• Chapter 7: Parameters
Provides detailed description of each parameter.
• Chapter 8: Error Codes and Warning Buzzer
Describes contents of error codes and how to
correct problems.
• Chapter 9: Inspecting Trouble and Recovering
Describes how to inspect and troubleshoot the
8720MC-RPS Regenerative Power Supply.
• Chapter 10: Special Replacement Parts
Provides a list of required replacement parts.
• Chapter 11: Outline Drawings of the Peripheral Devices
Provides outline dimensions of converters,
reactors, varistors, harmonic filters and line filters.
• Appendix A: Technical Specifications
Lists specifications of the 8720MC-RPS
Regenerative Power Supply in table form.
• Appendix B: Default Parameter Settings
Provides the default values of the parameters in
table form.
• Appendix C: Control Block Diagram
Provides a control block diagram.
This manual is intended for electrical personnel familiar with the
operation of this equipment and the hazards involved.
1-2
Contents of This Manual
Assumptions About the
Audience
- 8720MC Regenerative 1
- Power Supply 1
- Important User 3
- Information 3
- EMC Directive 4
- Low Voltage Directive 4
- European Communities 4
- (EC) Directive 4
- Compliance 4
- Table of Contents 5
- Start and Adjustment 6
- Operation Panel 6
- Parameters 6
- End of Table of Contents 8
- Contents of This Manual 9
- Assumptions About the 10
- Audience 10
- CAUTION ! 11
- About 8720MC-RPS 13
- Regenerative Power Supply 13
- Power Rating 14
- Appearance of the 8720MC 14
- RPS Regenerative Power 14
- PROGRAM kW 16
- Main Components and 17
- Locations 17
- Unit Front Side 19
- 8720MC-RPSxxxvm-HV2 20
- Synchronous Rectifier 21
- Figure 2.1 22
- Figure 2.2 23
- 8720MC-RPS065 24
- (TB4) for Model 8720MC-RPS190 25
- Sequence Signal 26
- Terminal Block (TB3) 26
- Microprocessor 26
- Jumpers and Switches 27
- 8720MC-RPS 29
- Installation 31
- Required Total Area 32
- Figure 3.2 34
- Max. 250 (9.8) 35
- Unit: Millimeters (inch) 36
- Notes on Installation 37
- Chapter 4 39
- Regenerative 42
- Figure 4.4 45
- [A] = (8 0.03 x R 46
- [Ω]) x C [µF] 46
- Figure 4.5 48
- Installing Circuit Breaker 49
- Installing Reactor 50
- Installing Varistor 51
- Installing Line Filters 52
- Installing Harmonic Filter 52
- Installing Input Fuses 52
- Bus Bar and Output Fuses 53
- Figure 4.6 55
- Model 8720MC-RPS190 Unit 55
- Figure 4.7 56
- Figure 4.8 58
- Model 8720MC-RPS190 58
- Regeneration Mode only 60
- EMC Filter Unit 63
- 8720MC-RPS190 63
- Wiring To Comply with EMC 68
- 8720MC-RPS Unit 70
- Figure 4.18 74
- Wiring with Ribbon Cables 74
- Notes on Wiring 75
- Powering up the 8720MC-RPS 78
- Operating the 8720MC-RPS 79
- Monitor Mode 88
- Program Mode 89
- Status LEDs 91
- U.002 REV Current Limit 96
- U.001 FWD Current Limit 96
- Factory Parameters 97
- F.011 Deadtime 102
- (Note 1) 104
- F.018 Version Information 105
- End of Chapter 106
- Warning Buzzer 107
- Error Codes and 107
- Contents of Error Codes 108
- Recovering from Fatal Error 112
- Inspecting Trouble and 113
- Recovering 113
- Preliminary Review 114
- Troubleshooting Flow 114
- DC Bus Voltage Does Not Go Up 115
- Special Replacement Parts 117
- Outline Drawings of 119
- RPS190BS units 120
- Outline Drawing of 121
- 8720MC-EF190-VB 126
- EMC Filter Unit for 126
- Model 8720MC 126
- RPS190BM and 126
- 8720MC-RPS190BS 126
- Figure 11.4 127
- Technical Specifications 129
- End of Appendix 130
- Default Parameter Settings 131
- Control Block Diagram 133
© 2020, manymanuals.es. Todos los derechos reservados | 0.093 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales