
Installing Your Mass Storage System
Chapter 3
310
Figure 1.11
You
can Connect up to Three 1770M10 Systems to the Peripheral
Communication Module
Blue
Shield
Clear
11967
1775GA
Peripheral
Communication
Module
1770CD
Twinaxial
Cable
To another Peripheral Communication Module
1770M11
Mass Storage System
1770M10
Mass Storage System
To another
1770M10 system
P/N 96618901
Connector Cable
1. By hand, remove the internal single inline packs (SIPs) located on the
Disk Controller Module of the 1770-M11 system. Refer to Figure 1.12.
Figure 1.12
Remove
the Single Inline Packs (SIPs) Located on the Disk Controller Module
Single Inline Packs (SIPs)
11968I
2. Set the switch assembly of the 1770-M10 system to a unit number. Only
use the unit numbers 1, 2, and 3. Refer to table 3.A. for the switch
assembly settings. if you connect more than one 1770-M10 system, each
Comentarios a estos manuales