Allen-Bradley Rockwell Automation 1734-AENT Manual de usuario Pagina 57

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 230
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 56
57Publication ENET-UM001I-EN-P - January 2010 57
Chapter
5
Configure a Supervisor on a Device-level
Ring Network
Introduction
A Device-level Ring (DLR) network is a single-fault tolerant ring network
intended for the interconnection of automation devices.
The ring topology provides:
•media redundancy.
fast network fault detection and reconfiguration.
the resiliency of a single-fault tolerant network.
easy implementation without any additional hardware requirements.
Topic Page
Rockwell Automation Products with Embedded Switch Technology 58
Construct the Physical Network 63
Configure Supervisor Nodes on a DLR Network 64
Complete the Physical Connections of the Network 74
Verify Supervisor Configuration 75
Troubleshoot DLR Network Issues 75
This section describes how to configure a ring supervisor on a
DLR network. This section does not fully describe a DLR
network itself.
See the EtherNet/IP Embedded Switch Technology Application
Guide, publication
ENET-AP005
, for information on:
a DLR overview.
how to fully configure a DLR network.
how to monitor a DLR network.
how to troubleshoot a
DLR network.
Vista de pagina 56
1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 229 230

Comentarios a estos manuales

Sin comentarios